See photos (2)

From la Chapelle to Clot by the GR 54

Sport, Pedestrian sports, Hiking itinerary in La Chapelle-en-Valgaudémar
14.7 km
  • Going from hamlet to hamlet is a good start for taking in the built heritage and history of Haut Valgaudemar before setting off to the summits.

  • Opposite the Tourist Information Centre in La Chapelle, the GR54 footpath starts between the bar and the souvenir shop and heads up the valley to Le Clot. Follow the footpath that more or less follows the left bank of the Sèveraisse stream up to the hamlet of Bourg. Here, a footbridge at the bottom of Bourg enables you to cross to the right bank. The footpath continues to climb a little before reaching the hamlet of Rif du Sap. The route is then very peaceful up to old hamlet of Le Clot, via...
    Opposite the Tourist Information Centre in La Chapelle, the GR54 footpath starts between the bar and the souvenir shop and heads up the valley to Le Clot. Follow the footpath that more or less follows the left bank of the Sèveraisse stream up to the hamlet of Bourg. Here, a footbridge at the bottom of Bourg enables you to cross to the right bank. The footpath continues to climb a little before reaching the hamlet of Rif du Sap. The route is then very peaceful up to old hamlet of Le Clot, via the Xavier Blanc mountain refuge where it is possible to quench your thirst. This footpath is also the return route but it is possible to catch the shuttle for the return journey.

    Medium
  • Departure
    La Chapelle-en-Valgaudémar
  • Departure : La Chapelle-en-Valgaudemar.
    After Les Richards bridge, on the N85, turn right onto the D985a. La Chappelle is approximately 18 km from here.
    Parking recommended : At the exit of the village of La Chapelle. .
    Bus stop at St Firmin on the Gap-Grenoble route. From there, shuttle service possible. Be sure to reserve 36 hours in advance at 05voyageurs.com or by calling 04 92 502 505.
  • Documentation
    GPX / KML files allow you to export the trail of your hike to your GPS (or other navigation tool)
Close